LENVII
By LENVII | 20 July 2020 | 0 Comments

HENEX HC-300R Instructions

 

Introduction of HC-300R menu setting function

 

 

To enter the function setting, please press the Up/Down buttons at the same timez.

Function menu, select setting function up or down.

 


1. Wireless 2. 4G and USB receiver paired connection
(Note: the default factory has been paired to receive the USB connection)

 

Enter the function menu, select "Connection mode"------"SCAN" (confirm button)------"2. 4G"--------"SCAN"
-----" Down button "------"RETURN"-------"SCAN"-------"Down button "------"Wireless setting"----- -"SCAN"
-----"MatchingMode"------"SCAN"-----(Enter the pairing mode and notice the screen flashing.
Connect the USB receiver to the USB interface. Listen A beep sound indicates that the pairing is successful.
If you do not hear the beep sound for a long time, please operate the pairing setting again).

 
 


2. Turn on Bluetooth mode.

 

Enter the function menu, select "Connection mode"------"SCAN" (confirm button)------"HID"--------"SCAN"
-----"Down Button "------"RETURN"-------"SCAN"-------"Down button "------"Wireless setting"------" SCAN"
-----"MatchingMode"------"SCAN"-----(Enter the pairing mode and notice that the screen flashes.
Open the Bluetooth device that needs to be connected, and find the scanner's Bluetooth pairing name: BarCode Scanner HID.
If you hear a beep, it means the pairing is successful. If you have not heard the beep for a long time, please operate the pairing settings again).

 


3. Turn on the barcode storage acquisition inventory scan mode.

 

Enter the function menu, select "Transport Mode" --------"Scan" (confirm button)------"Inventory mode" --------"Scan"
----- "Down" button "------"Return" -------"SCAN" -----"Down" -----"Return"
(Enter inventory mode, and pay attention to the screen In the upper right corner, whether there is an upper house display.
The scanner has finished storing the barcode, uploading) Enter the function menu ----- "Down"
------Transport Mode------Data upload (Note: uploading needs to Connect the USB receiver to the USB port)--------"SCAN"
--------Normal mode (If you need to convert the barcode scanner to normal wireless 2. 4G barcode scanning function, please select normal Mode)

Leave a Reply

Your email address will not be published.Required fields are marked. *
Name
E-mail
Content
Verification code